ACCREDITED ISO 17025
Durometer Test Stands
STEEL HARDNESS TESTERS
PTC® TRAINING HANDCUFFS
6" BENCH POLARISCOPE
Melting Point Meter
PTC® OUTLET STORE
Direct Contact Spot Check® Thermometers
Spot Check® Thermometers with Stainless Steel Dial
Spot Check Thermometer / Stainless Steel Dial
Direct Contact Spot Check® High Temp Thermometers with Stainless Steal Dial
Write a Review
PTC® Direct Contact Spot Check® Thermometers with Stainless Steal Dial
Made in the U.S.A.
Please Select Temperature Range F or C
Spot Check® Stainless Steel Dial 0° to 525°C #575CMSS
Spot Check® Stainless Steel Dial 50° to 1000°F #575FMSS
Add Surface Temperature Calibration Certificate
No Written Calibration Certificate Required
NIST/A2LA (ISO 17025) 3 Logged Points $275.00
NIST Traceable Basic Cert No Points $135.00
Put me on the Waiting List
Add to Cart
PTC® Direct Contact Spot Check® Surface Thermometers with Stainless Steel Dial, Comes with magnetic leaf spring, min-max hands and stainless steel dial for use in a vacuum chamber.
These thermometers come with stainless steel dials that are designed for use in vacuum chambers.
Models 575FMSS and 575CMSS feature dials with no paint or ceramics that could out-gas. The dials are etched to provide the temperature markings. These thermometers are made with uncoated metals.
These models feature two ancillary hands that act as Max-Min indicators, a spring lifter knob (Part No. 575.8) and a magnet and leaf spring assembly (Part No. 310.7).
PTC® Quality -- Made in the U.S.A.
Units Come to Temperature in Less Than One Minute
Accuracy of ±2% of Full Scale Range
NIST Certification Available
Every Unit Individually Calibrated
Stainless Steel Dial
Accuracy ±2% of full scale range
Diameter 1-3/4 in. (4.4 cm)
Height 1/2 in. (1.3 cm)
Weight 1/2 oz. (14 g)
Shipping weight 1 lb. (454 g)
The Model 575CMSS features two ancillary hands that act as Max-Min indicators. This model comes with a spring lifter knob and a magnet and leaf spring assembly USE CAUTION WHEN REMOVING INSTRUMENT FROM A HOT SURFACE. To prevent injury, a pair of tweezers can be used to grip the lifter knob or center post.
Use the magnet assembly to hold the thermometer in place on nonhorizontal ferrous surfaces by placing the hole of the leaf spring over the center post. Remove spring lifter knob if already attached. DO NOT ATTEMPT TO BOLT THE LEAF SPRING DOWN WITH THE NUTS ON THE INSTRUMENT. Bend the leaf spring enough to hold the instrument flat against the surface.
Spot Check® Contact Surface Thermometers
Spot Check® Thermometers with Magnetic Leaf Spring
Spot Check® Thermometers with Magnetic Leaf Spring/Max-Min
Recently Viewed Items
Turn History Off