Durometer Shore E Digital PTC® e2000 #511E (ISO 17025 Certification Included)

Meets or exceeds current ASTM D2240 Specs

Range (Type E) 0-100 points

Accuracy of ±1 Point

Height 6 in. (15.2 cm) 

Width 2-1/4 in. (5.7 cm)

Depth 1-1/2 in. (3.8 cm)

Weight 13 oz. (170 g)

Shipping Weight 4lb (1.4kg)

CALIBRATION CHECK

For a complete calibration check of mainspring, and visual and mechanical check of indenter, the instrument should be returned to PTC® (see Guarantee & Calibration Service) or refer to ASTM D2240 Specifications. PTC® recommends the unit be returned at least every 12 months for this check. For a quick field check, follow the guideline below. Under no circumstance should a test block be used as a standard to calibrate a durometer.

1. The pointer should read zero when no force is applied to the indenter of the durometer.

2. Hand hold the durometer and insert the indenter into the hole of the calibrated test block. Apply enough force to make firm contact between the top surface of the test block and the presser foot. The dial reading should agree with the value stamped on the check block (±1). Several tests should be made and the results averaged.

3. The indenter must protrude 0.098 to 0.100 inches below the presser foot.

4. When the indenter is fully displaced, the durometer should read 100 points. Use care as to not damage the tip of the indenter.